Beko BA309C - Faults Diagnosis

Local ar condtoner / Instructon Manual
41 / 276 EN
Please check the machne accordng to the followng form before askng for mantenance:
Problem Possble cause Troubleshootng
Unt does not turn on when
pressng On/Off button
P1 Error code
The water collecton tray s
full. Turn off the unt, dran
the water from the water
collecton tray and restart the
unt.
In cool mode: room
temperature s lower than
the set temperature
Reset the temperature
Unt does not cool well
The ar flter s blocked wth
dust or anmal har
Turn off the unt and clean the
flter accordng to nstructons
Exhaust hose s not connected
or s blocked
Turn off the unt, dsconnect
the hose, check for blockage
and reconnect the hose
The unt s low on refrgerant
Call a servce techncan to
nspect the unt and top off
refrgerant
Temperature settng s too
hgh
Decrease the set temperature
The wndows and doors n the
room are open
Make sure all wndows and
doors are closed
The room area s too large Double-check the coolng area
There are heat sources nsde
the room
Remove the heat sources f
possble
The unt s nosy and vbrates
too much
The ground s not level
Place the unt on a flat, level
surface
The ar flter s blocked wth
dust or anmal har
Turn off the unt and clean the
flter accordng to nstructons
The unt makes a gurglng
sound
Ths sound s caused by the
flow of refrgerant n-sde the
unt
Ths s normal
7 Faults dagnoss