Beko BA309C - Page 9

Local ar condtoner / Instructon Manual
9 / 276 EN
• Do not remove any fxed covers. Never use ths applance f t s not
workng properly, or f t has been dropped or damaged.
• Do not operate or stop the unt by nsertng or pullng out the power
cord plug.
• Do not use hazardous chemcals to clean or come nto contact
wth the unt. Do not use the unt n the presence of nflammable
substances or vapour such as alcohol, nsectcdes, petrol, etc.
• Always transport your ar condtoner n a vertcal poston and stand
on a stable, level surface durng use.
• Always contact a qualfed person to carry out repars. If the
damaged power supply cord must be replaced wth a new power
supply cord obtaned from the product manufacturer and not
repared.
• Hold the plug by the head of the power plug when takng t out.
• Turn off the product when not n use.
• Warnng Do not use manuals to accelerate the defrostng process
or to clean, other than those recommended by the manufacturer.
The applance shall be stored n a room wthout Contnuously
operaton gnton sources (for example: open flames, an operaton
gas applance or an operatng electrc heater.) Do not perce or burn.
Be aware that refrgerants may not contan an odour.
• The applance shall state the nsulaton of a resdual current devce
(RCD) havng rated resdual operatng current not exceedng 30mA.
• Ths applance s ntended to be used n household and smlar
applcatons such as
1 Safety precautons