Beko BT3122IS User Manual (English)

Questions and Answers:

P
Patty TaylorAug 20, 2025
Why does my Beko BT3122IS take so long to dry?
- K
  Kristen BanksAug 20, 2025
  The drying operation may take too long for several reasons. The fibre filters (both interior and exterior) might be clogged, the front side of the condenser could be blocked, or the ventilation grills may be obstructed. Insufficient ventilation in a small installation area, limescale on the humidity sensor, overloading the machine, or insufficiently spun laundry can also extend drying time. To resolve this, wash the fibre filters with warm water and dry them, clean the condenser, remove any obstructions from the ventilation grills, improve ventilation by opening doors or windows, clean the humidity sensor, avoid overloading the dryer, and ensure laundry is spun at a higher speed in the washing machine.
J
jonathan24Aug 22, 2025
What to do if my Beko BT3122IS does not turn on or start?
- L
  Latoya WalkerAug 22, 2025
  If your Beko Dryer isn't turning on, first ensure the power plug is properly plugged in. Also, check that the loading door is completely closed. Make sure the program is correctly set and not in standby mode, and verify that the child lock is deactivated. If the child lock is active, turn it off.
C
curryemilyAug 25, 2025
Why is water flowing from the loading door of my Beko Dryer?
- F
  friceAug 25, 2025
  Water may flow from the loading door because fibres might have gathered on the inner surfaces of the loading door and on the surfaces of the loading door gasket. Clean the inner surfaces of the loading door and the loading door gasket surfaces.
M
mayernancyAug 26, 2025
What to do if my laundry comes out damp after drying in my Beko Dryer?
- C
  Carl SilvaAug 27, 2025
  If your laundry is damp after drying, it could be due to several reasons. Ensure you are using the correct program for your laundry type by checking the care labels. Clogged fibre filters (interior and exterior) or a blocked condenser can also cause this issue. Overloading the dryer or not spinning the laundry enough beforehand can also leave clothes damp. Wash the fibre filters with warm water and dry them and clean the front of the condenser. Avoid overloading the drying machine and spin the laundry at a higher speed in the washing machine before drying.
D
Debbie MossAug 27, 2025
Why is the fibre filter cleaning icon lit on my Beko Dryer?
- J
  Jennifer JohnsonAug 27, 2025
  The fibre filter cleaning icon lights up because the fibre filters (interior and exterior) may be unclean, a layer may have formed in the fibre filter pores, leading to clogging, or the fibre filters may not be in place. It can also indicate that the eco-friendly filter cloth may not be installed on the plastic part, and the front of the condenser may have clogged or eco-friendly filters may not have been replaced. Wash the filters with warm water and dry them, insert the interior and exterior filters into their places, install the eco-friendly filter to the plastic part and place it on the filter housing, or replace your filter.
J
John SmithAug 29, 2025
Why is the condenser warning icon flashing on my Beko Dryer?
- R
  Richard RichardsAug 29, 2025
  The condenser warning icon flashes if the condenser front may be clogged with fibres, or if the fibre filters may not be in place. Clean the front of the condenser and insert the interior and exterior filters into their places.
J
Joseph LynchAug 31, 2025
What to do if the filters may be dirty on Beko BT3122IS Dryer?
- B
  Beth JosephAug 31, 2025
  Clean the inner and outer filters or replace the eco-friendly filter.
G
Gregory HansonSep 2, 2025
What to do if the program was interrupted for no reason on my Beko BT3122IS Dryer?
- M
  Matthew BushSep 2, 2025
  If the drying program is interrupted, first check that the loading door is properly closed. A power outage might have occurred; if so, press the Start / Standby / Cancel button to restart the program. Also, the water tank might be full, so empty the water tank.
C
christinathomasSep 3, 2025
Why is the water tank warning symbol on or flashing on my Beko BT3122IS?
- V
  Veronica LaneSep 4, 2025
  The water tank warning symbol illuminates when the water tank is full, so you should empty it. Also, if your product is connected directly to the water discharge, the water discharge hose might have folded, so check the hose.
L
lamlaurenSep 5, 2025
How to fix a Beko BT3122IS Dryer loading door that opens by itself?
- J
  Jasmine ColeSep 5, 2025
  If the loading door opens by itself, it might not be closed properly. Push the loading door until you hear the closing sound.