EasyManua.ls Logo

Beko BT593IB - User Manual

Beko BT593IB
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Dryer
User Manual
Asciugatrice
Manuale utente
BT593IB
EN / IT
2960313341_EN/ 13-06-22.(9:50)

Table of Contents

Questions and Answers

  • R
    Rachael GrayAug 17, 2025
    Why does my Beko Dryer take so long to dry?
    • R
      richardsimmonsAug 17, 2025
      Several factors can cause your Beko Dryer to take longer than usual: the fibre filters may be clogged, the condenser front might be blocked, the ventilation grills could be obstructed, or the room may be too small causing inadequate ventilation. A lime layer on the humidity sensor, overloading the machine, or insufficient wringing of the laundry can also extend drying time. To resolve this, wash the fibre filters, clean the condenser, remove any obstructions from the ventilation grills, improve room ventilation, clean the humidity sensor, avoid overloading the dryer, and ensure laundry is adequately wrung before drying.
  • R
    rubenkellyAug 19, 2025
    What to do if the Beko BT593IB doesn't turn on?
    • R
      Rebecca RamosAug 19, 2025
      If your Beko Dryer isn't turning on, first ensure that the power cord is properly plugged in. Check that the loading door is fully closed and that a program is correctly set, and not in the paused position. Also, verify whether the child lock is activated and, if so, deactivate it.
  • G
    glittleAug 22, 2025
    Why are my clothes still damp after drying in my Beko BT593IB?
    • A
      Andrew WestAug 22, 2025
      If clothes are damp after a drying cycle in your Beko Dryer, it might be due to using an unsuitable program for the laundry type. Other potential causes include clogged fibre filters or a blocked condenser front. Overloading the dryer or not wringing the laundry sufficiently beforehand can also leave clothes damp. Ensure you select the correct program, clean the filters, clear the condenser, avoid overloading, and wring clothes thoroughly before drying.
  • H
    Hunter HarrisAug 25, 2025
    Why is the water tank warning symbol on my Beko BT593IB Dryer?
    • L
      lauraperezAug 26, 2025
      The water tank warning symbol on your Beko Dryer indicates that the water tank may be full and needs to be emptied. Alternatively, if your dryer is connected directly to a water drain, the water discharge hose might be collapsed, so check the hose.
  • T
    Timothy DeanAug 27, 2025
    Why is the fibre filter cleaning icon lit on my Beko BT593IB?
    • J
      justinlaraAug 27, 2025
      The fibre filter cleaning icon lights up on your Beko Dryer when the fibre filter may be unclean, or a layer may be formed on the fibre filter pores that leads to clogging. It may also indicate that the fibre filters are not inserted correctly. To resolve this, wash the filters with warm water and dry them, and ensure they are properly inserted.
  • R
    rodriguezchrisAug 30, 2025
    Why is the condenser warning icon flashing on my Beko Dryer?
    • A
      Adrian McclainAug 30, 2025
      The condenser warning icon flashes on your Beko Dryer if the condenser front is clogged with fibres, or if the fibre filters are not correctly inserted. Clean the front side of the condenser and ensure that the interior and exterior filters are properly placed.
  • F
    feliciarobinsonSep 2, 2025
    Why is water dripping from the Beko BT593IB Dryer loading door?
    • D
      Diamond AndrewsSep 2, 2025
      If water drips from the loading door of your Beko Dryer, it may be due to fibres gathered on the inner sides of the loading door and the loading door gasket. Clean these inner surfaces to resolve the issue.
  • M
    Michael ChoiSep 5, 2025
    What to do if the Beko Dryer program stopped for no reason?
    • J
      jose42Sep 5, 2025
      If your Beko Dryer program stops unexpectedly, make sure that the loading door is properly closed. A power outage could also be the cause; if so, press the Start / Pause / Cancel button to restart the program. Lastly, check if the water tank is full and empty it if necessary.
  • W
    Wyatt OrtizSep 7, 2025
    Why have my clothes shrunk in my Beko Dryer?
    • M
      Matthew OlsenSep 7, 2025
      Clothes may shrink, harden, or spoil in your Beko Dryer if a program not suitable for the laundry type was used. Always check the maintenance labels on your clothes and select an appropriate program.
  • C
    Carolyn MurphySep 10, 2025
    What to do if the loading door opens by itself on my Beko BT593IB?
    • K
      kathy94Sep 12, 2025
      If the loading door of your Beko Dryer opens by itself, push the loading door until you hear the closing sound to ensure it is properly latched.

Beko BT593IB Specifications

General IconGeneral
Appliance placementFreestanding
Loading typeFront load
Rated capacity9 kg
Drying classB
Noise level65 dB
Energy efficiency classB
Heat sourceElectric
Width60 cm
Height85 cm
Number of Programs15
Delay StartYes
Child LockYes
Drying programsCotton, Wool
Depth55 cm
Dimensions (H x W x D)85 x 60 x 60 cm

Related product manuals