Belkin Wireless G Plus MIMO Router F5D9230-4 - Page 95

91
Manually Configuring Network Settings
section
1
9
2
3
4
5
6
7
8
10
4.
Select the “TCP/IP” tab
(3)
. Next to “Configure”
(4)
, you should see
“Manually” or “Using DHCP”. If you do not, check the PPPoE tab
(5)
to make sure that “Connect using PPPoE” is NOT selected. If it is,
you will need to configure your Router for a PPPoE connection type
using your user name and password.
5.
If “Manually” is selected, your Router will need to be set up for a
static IP connection type. Write the address information in the table
below. You will need to enter this information into the Router.
6.
If not already selected, select “Using DHCP” next to “Configure”
(4)
,
then click “Apply Now”.
Your network settings are now configured for use with the Router.