Setting WPA/WPA2
1.
Select “WPA/WPA2-Personal (PSK)” from the “Security Mode”
drop-down box.
2. Select “WPA-PSK” for just WPA authentication, or “WPA2-PSK” for
just WPA2 authentication, or you may select “WPA-PSK + WPA2-
PSK” for WPA and WPA2 as the authentication type.
3. Enter your pre-shared key. This can be from eight to 63 characters
and can be letters, numbers, or symbols. This same key must be
used on all of the clients that you set up. This
pre-shared key will allow users full access to your network
including shared files and printers.
4. Click “Apply Changes” to finish. You must now set all clients to
match these settings depending on the type of access you want
them to have.
To Next Page
Loading...
