Bella extract-pro User Manual

18
TROUBLESHOOTING
Problem Cause Solution
When a PRE-PROGRAMMED/
SPEED button is pressed,
all lights on the control panel
begin to ash. Blender will not
operate.
Blender jug or tumbler is
not correctly assembled
onto the motor base.
• Press the ON/OFF button to reset. Reposition the blender jug
or tumbler. Align 3 locking tabs on the blade collar with 3 slots
on the motor base. Press down rmly on the blender jug lid or
tumbler and turn clockwise until the tabs lock into position.
• Press any PRE-PROGRAMMED/SPEED button to
resume operation.
The blender motor rotates very
slowly.
Blender jug or tumbler is
overloaded.
• Remove some food from the tumbler or the blender jug and
continue blending.
• Add liquid to the blender jug or tumbler and continue blending.
Ingredients are not mixing
together well.
Heavier ingredients have
fallen to the bottom.
• If necessary, remove blender jug or tumbler and shake
ingredients to re-distribute. Continue blending.
• If the puree is still not blended smoothly, it may be necessary
to add liquid to the blender jug or tumbler and continue
blending.
The Blender has stopped
operating. All control panel
lights are ashing.
• A hard or brous
ingredient, such as a chunk
of carrot or celery can
get stuck in the blade and
prevent it from turning.
• The motor has
overheated.
• Remove the blade attachment and remove any debris,
if necessary. Stir food and replace blade.
• Allow the Blender to rest for at least 3 minutes. Then replace
blender jug or tumbler and continue blending.
The tumbler has leaked. Wet ingredients have been
used with the Grinding
Blade.
The grinding blade should only be used with dry ingredients.
Change to the cross blade which is for wet ingredients.
CARE AND CLEANING
Cleaning
Always unplug your Bella Extract Pro Blender before cleaning it. Take care the blades are very sharp. Use the
plastic collar when handling the blades.
WARNING! Never immerse the motor base, plug or cord in water or any other liquid.
Use only mild detergent when cleaning. Do not harsh abrasive cleaners as these will damage the cosmetic
appearance.
1. Wherever possible it helps to rinse attachments and accessories immediately after use, this will make
clean up easier.
2. For a quick clean up ll the blender or tumbler ¼ full with clean warm water attach the blade unit and
process on LOW for 5 seconds. Rinse and dry thoroughly.
3. If necessary soak the Jug, Tumbler and Blades in warm soapy water for 10 to 15 minutes. Use a soft
dishwashing brush to remove any deposits.
4. Wash all lids and tumbler lids in warm soapy water and rinse and dry thoroughly.
5. All attachments and accessories except motor base are dishwasher safe top rack only.
6. Wipe the motor base with a soft damp cloth.
STORAGE
1. Unplug and clean blender.
2. Store in original box or in a clean, dry place.
3. Never store the Blender immediately after use or while it is plugged in.
4. Never wrap cord tightly around the appliance. Never place any stress on cord, especially where the cord
enters the motor base, as this could cause the cord to fray and break.
SERVICING
If you drop or damage your Blender it should not be used until it has been examined by a qualied appliance
technician. Always refer servicing to qualied service personnel.

Bella extract-pro Specifications

General

Brand	Bella
Model	extract-pro
Category	Blender
Language	English