7
ASSEMBLY INSTRUCTIONS
WARNING: ALWAYS MAKE SURE COLD PRESS JUICER IS UNPLUGGED
BEFORE STARTING ASSEMBLY.
IMPORTANT: The Cold Press Juicer’s safety system prevents the unit from being turned ON
unless it is completely and properly assembled.
1. Place the motor base on a at, stable surface.
2. Check to make sure the groove in the rubber seal ring is properly attached to the center hole
in the bottom of the processing bowl. (See Figure 2.)
3. Line up the black bar of the processing bowl with the motor base handle, making sure
the 4 bowl locks on the motor base are directly above the 4 holes in the bottom of the
processing bowl. Press down rmly. An audible click can be heard as the processing bowl locks
in place. (See Figure 3.)
FIGURE 2 FIGURE 3
Rubber Seal Ring
Bowl Locks
Bowl Locks
Processing
Bowl
Groove
Center Hole
SO-309848_BELLA NutriPro_IM_r5.indd 7 12-09-04 2:18 PM
To Next Page
Loading...
Need help?
General
