8
4. Watching through the clear processing bowl, attach the base of the crushing auger through
the processing bowl’s center hole and over the motor base spindle. (See Figure 4.) Make sure
the crushing auger drops down and rests ush against the bottom of the processing bowl.
When securely attached, the crushing auger will not turn on the motor base.
5. Add the juice strainer over the crushing auger. (See Figure 5.) The groove in the bottom
of the juice strainer lines up and locks over the locking ring in the bottom of the processing
bowl. When securely attached, juice strainer will not turn on the motor base.
FIGURE 4 FIGURE 5
Auger
Motor Base
Spindle
Locking Ring
Juice Strainer
Groove
SO-309848_BELLA NutriPro_IM_r5.indd 8 12-09-04 2:18 PM
To Next Page
Loading...
Need help?
General
