COMMISSIONING
The installer must test the operation of the appliance.
Burner aeration
All burners have xed aeration and no adjustment is possible.
Pressure setting
Natural Gas @ 1.00kPa
Pressure test point
The pressure test point is tted on the outlet of the regulator or on an adapter which should be tted
onto the outlet of the regulator.
Hob burner
Turn the control knob to the FULL ON position, wait a second before pressing the ignition switch or
holding a lighted match or taper to the burner. Hold the control knob in for 15 seconds. Do not hold the
control knob in for longer that 15 seconds. If the burner fails to light within this time, release the control
knob and wait one minute before attempting further ignition.
Maintenance Schedule
It is recommended that the appliance is inspected annually as part of a routine Maintenance Schedule,
to ensure the electrical and gas components are in satisfactory condition
Before leaving the installation hand over the User Guide to the customer
To Next Page
Loading...
