The oven door is made up of 3 panes of glass and has vents at the top and bottom. When the oven is operating, air
is circulated through the door to keep the outer pane cool. If condensation has worked its way in between the glass
panes, the door can be dismantled in order to clean in between the panes.
Remove the door as per above instruction and place it on a protective surface (e.g. on a table cloth) to prevent it
getting scratched. The door handle should line up with the edge of the table. Make sure the glass lies flat to avoid
breakage of glass during cleaning.
1. Undo the 2 screws on upper bracket.
2. Take out upper bracket and first pane of glass.
3. Loosen the 4 clips.
4. Slide out middle pane of glass carefully. Clean the glass panes and other parts with a damp microfiber cloth or a clean
sponge and a solution of hot water with a little washing-up liquid. Wipe dry using a soft cloth.
In order to obtain easier access to the oven chamber for
cleaning, it is possible to remove the door.
the safety catch part of the hinge upwards. Close the
door lightly, lift and pull it out towards you. In order to fit
the door back on to the a, do the reverse. When fitting,
ensure that the notch of the hinge is correctly placed on
the protrusion of the hinge holder. After the door is fitted
to the oven, the safety catch should be carefully lowered
If the safety catch is not set it may cause
damage to the hinge when closing the door.
Middle Layer Glass Removal
12
To Next Page
Loading...
