B. SENDING THE ROBOT BACK TO THE CHARGING STATION
I. For one cycle (Return to station, F1)
If you want the robot to continue mowing after it has recharged:
a. Stop the machine by raising the hood.
b. Press F1. The screen will display: “O01 GoToChge: √ “
c. Press to start the robot again.
d. Close the hood in the next 8 seconds.
II. For several cycles (Rest at station, F2)
If you want the robot to remain at the charging station until further notice:
a. Stop the machine by raising the hood
b. Press F2. The screen will display: “O02 Stay@Chge: √“
c. Press
to start the robot again.
d. Close the hood in the next 8 seconds.
If you want the robot to restart its mowing cycles after an “F2” rest period at the charging
station:
a. Raise the hood of the robot at the station.
b. Press
to start the robot again.
c. Close the hood in the next 8 seconds.
d. The robot will leave the station again once its batteries have been fully recharged.
C. VISUAL AND AUDIO SIGNALS
Your Belrobotics robot conveys messages about its status through beeps or information
displayed on the screen.
The station also conveys messages about its status through a two-coloured LED light.
- 1 long beep: Stop robot or incorrect key
has been pressed
- 1 short beep: Key has been pressed
- 2 long beeps / 10 sec: Charge robot
- 2 short beeps / 1 sec: Cutting heads
starting up
- 1 short beep /2 sec: Alarm
- Blinking green light: OK, normal mode
- Blinking red light: boundary wire has
been cut or is too long (usually >
1200m)
- Continuous red light: failure of the
station’s electronic card or wire is
too short (usually < 200m)
- No colour: the station is not connected
to an electricity supply.
- FC: Fast Charge, normal mode
- SC: Slow Charge, rest mode
- WU: Wait User
- WT: Wait programmed Timers
- W.BH: Wait Battery too Hot
- W.FT: Wait Freezing ambient
Temperature
To Next Page
Loading...
