Belrobotics PARCMOW - Cutting Head Replacement

23
B
B
E
E
L
L
R
R
O
O
B
B
O
O
T
T
I
I
C
C
S
S
E. CUTTING HEADS
The cutting heads are the main determiners of the mowing result. You are advised to check
them at least once a month and replace them when they are worn out. It is advisable to
change them at the beginning of the season and during the month of June.
Use the following procedure for changing the cutting heads:
1. Make sure the machine is switched OFF and wear protective gloves.
2. Lift the robot.
3. Place the disk opening opposite the top of the screw attaching the cutting head.
4. Unscrew the cutting head.
5. Remove the new part from its packaging.
6. Insert the new cutting head and screw it in.
If you have any doubts about this process or attaching one of your cutting heads, please
contact your supplier.
9. INSTALLATION
The installation of the boundary wire and the charging station are essential to ensuring your
robot can work effectively.
Furthermore, the electrical installation (connecting the charging station to the electricity
supply) must be carried out by a professional.
It is therefore highly recommended that an authorised professional carry out the
installation process from start to finish.