Belrobotics PARCMOW - Page 25

25
B
B
E
E
L
L
R
R
O
O
B
B
O
O
T
T
I
I
C
C
S
S
Situation
Explanation
Solution
5
The robot remains at
the station for a long
time and does not
move away.
1
Screen displays: SC
(see §7.C, p.15)
The grass in the mowing area has
been adequately cut. The robot is
now resting at the station to save
energy and avoid damaging the
ground unnecessarily.
This situation is normal.
The robot will continue its
work cycle again when
necessary.
2
Screen displays: WU
(see §7.C, p.15)
The robot has been manually
brought to the charging station by a
user and won’t start working again.
If you want the robot to
switch on automatically
after a manual charge,
please press .
3
Screen displays: WT
(see §7.C, p.15)
The robot is resting during a
programmed rest period.
This situation is normal.
The robot will continue its
work cycle again when
necessary.
4
Screen displays: W.BH or W.FT
(see §7.C, p.15)
The robot is not working as its
battery temperature is too high or
too low. This helps to avoid damage
to the batteries or the land being
maintained.
This situation is normal.
The robot will continue its
work cycle again when
necessary.
5
Option O02: "Stay@Chge" has been
selected.
To restart the robot, press
.
6
Alarm message on
screen:
"No wire signal"
1
The LED at the back of the station is
not switched on.
The station is not connected to a
power supply.
Check the status of the
electricity supply to the
station. If the LED still does
not light up, contact your
dealer.
2
The LED at the back of the station is
flashing red.
The boundary wire has been cut or
damaged.
Contact your dealer.
3
The LED at the back of the station is
flashing green.
The problem could be coming from
the robot or from the ground.
Contact your dealer.