5
RADIO FUNCTION OPERATION
To start the radio application from the main system interface, just tap the icon.
To exit, tap the icon in the top left corner to return to the main system interface.
Press and hold the scan icon to activate auto-search. The system will automatically save the channels
according to the radio frequency once found. Touch the same icon again to stop searching
In the radio interface, press and hold (minimum of 2 seconds) the icons to switch between
available radio stations. This will allow you to only select stations with strong signal strengths. You
can also just tap on the icons to step forward 200 kHz in FM and 10kHz in AM.
You can save stations by pressing and holding on to the corresponding number you want to save the
station too.
Tap the icon to switch between FM1, FM2, FM3, AM1, and AM2.
You can also quickly select particular stations by taping on a particular place on the radio
frequency line.
If you want to edit the audio settings tap the icon to enter the audio settings
NOTE: Before searching station, touch the icon to select long or short-distance searching.
When “LOC” is displayed on the screen, only the local radio stations with a strong signal can be
searched; when “LOC” is hidden, both long and short-distance radio stations will be searched for.
You can store up to 18 FM radio stations (FM 1 / 2 / 3) and up to 12 AM radio stations (AM 1 / 2).
NOTE:
1. The LOC function setup is invalid while using AM wave band
2. The TUNE button on the panel can be used to adjust the frequency steadily while searching for
radio stations
3. Touch the icon to go into station scanning mode and to be able to listen to the stations for
5 seconds each.
ENTER/EXIT
Automatic station searching
Searching & saving stations
Waveband selection
Additional radio functions
To Next Page
Loading...
