To Next Page

To Previous Page

LC8810 User Manual V1.0

Boot Device Priority Sequence

To specify the boot sequence from available devices, enter the [Boot] menu. Then setup [Boot

Option Priorities] to choose the priority desired for the booting process from the list of available

boot devices.

I/O Configuration: Serial and Parallel Ports

To configure the serial ports, go to [Advanced] menu. Select [Super IO Configuration] and then you

will be able to choose / change the address and IRQ for all the ports.

For each serial ports, option is available to select power function on pin 9 of the port:

 Disabled

 +5V

 +12V

Video Configuration

The DVI-I video connector provides both analog VGA and Digital video output. For connection

to VGA displays, a DVI-to-VGA converter or DVI-to-VGA cable can be used. To select between

analog VGA video output and digital video output, select [Advanced] menu, then select

[Display Settings].

Network boot

If you desire to enable your system to boot from a network, go to [Advanced] menu. Then setup

[Network] option to select "UEFI only" or "Legacy only". Save the settings and reboot into

BIOS, the network boot options will then be available [Boot] menu.

Restore to Optimized Defaults

If the BIOS settings are accidently changed and it’s necessary to restore setting to the optimized

default values, select menu [Save & Exit] and then [Restore Defaults]. Select [Yes] in the

confirmation dialog box. Then select [Save Changes and Exit] (or press [F10]) to save the

changes.

Bematech LC8810 User Manual

Questions and Answers: