Bematech MP200 - Emulation Star Sp200

MP200 USER MANUAL
Page 11
5.3 EMULATION STAR SP200
Command
Hex Code
Description
BEL
<07>H
Differed drive command “A” for peripheral unit
(Default setting)
CAN
<18>H
Cancel print data in buffer
LF
<0A>H
Line feed
CR
<0D>H
Line feed (same as LF)
SO
<0E>H
Select expanded character mode
SI
<0F>H
Cancel expanded character mode
FS
<1C>H
Immediate drive command “B” for peripheral unit 1
DC4
<14>H
Cancel expanded character mode
ESC BEL
n1 n2
<1B>H<07>H<n1>
<n2>
Adjust drive pulse width for peripheral unit
(Default setting)
ESC @
<1B>H<40>H
Initialize printer
ESC M
<1B>H<4D>H
Select 7 x 7 (Half dots) character size
(Default setting)
ESC R n
<1B>H<52>H<n>
Select international character set
ESC P
<1B>H<50>H
Select 9 x 7 (Half dots) character size
ESC W 1
<1B>H<57>H<31>
H<1B>H<57>H<1>
Select expanded character mode
ESC W 0
<1B>H<57>H<37>
H<1B>H<57>H<0>
Cancel expanded character mode
ESC a n
<1B>H<61>H<n>
Feed paper n lines