4. Maintenance
The tube holder should be cleaned with a cloth dampened with a small amount of
alcohol. The outside of the unit can be cleaned with a damp cloth or mild
detergent if required.
The power switch is located on the rear of the instrument. After use,
the power to the instrument should be turned off. If the instrument will
not be used for a long period of time, it should also be unplugged and
covered with a cloth or plastic to keep it free of dust.
The instrument should be unplugged immediately and the supplier
contacted in the event of:
Liquid leaking into the instrument
Smoke or fire
Abnormal operation - ie sound or smell
The instrument has been dropped or outer housing damaged
Instrument function changes
Install the instrument in a cool, dry location free from dust, direct
sunlight or strong lights. The instrument should be placed away from
corrosive gasses, strong magnetic fields, and heat sources. Allow at
least 4 inches on all sides of the instrument for proper air circulation.
Be sure that the air vent at the back of the instrument is not blocked. If
using two instruments, they should be placed at least 3 feet apart.
If samples are processed for an extended time period, many
cycles or without a pause between cycles, thermal breakdown of
the sample tube may occur. Be sure to follow manufacturers
guidelines for lysing kits and tubes.
Always disconnect power to the unit before any cleaning procedure.
Do not apply cleaning solutions directly to the tube holder or chamber.
Do not use corrosive agents while cleaning. Do not submerge the
instrument.
To Next Page
Loading...