19
Operating the Appliance
6 720 610 604 GB (03.06)
3.8 Frost protection (Combi Appliances)
B Leave master switch switched on.
If the appliance is to be left for long periods switch the central
heating on and set the room temperature controller at 6°C.
B Add a suitable anti-freeze fluid to the water in the central heat-
ing system.
Suitable products are available from Betz-Dearborn Tel.: 0151
4209563, Fernox Tel.: 01799 550811 and Salamander Tel.:
0121 378 0952.
3.9 Fault Condition
In the unlikely event of a fault occuring while the appliance is in
operation:
The display and the text display then shows a fault code and the
button may also flash.
If the button flashes:
B Press and hold the button until the display shows “––”.
The appliance will then start up again and the display will show
the central heating flow temperature.
If the button does not flash:
B Switch the appliance off and then on again at the master
switch.
The appliance will start up again and the central heating flow
temperature will be displayed.
If the fault remains and can not be cleared:
B Call British Gas for assistance, giving a description of the fault
and, if possible, the fault code from the facia display.
To Next Page
Loading...
Need help?
General
