BendPak HDS-14LSXE User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
Four-Post Alignment Lifts
Installation and Operation Manual
Manual Revision F3 — April 2018 — Manual P/N 5900162
Models:
• HDS-14LSX
• HDS-14LSXE
Model HDS-14LSXE shown.
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠ DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with installation and operation,
you agree that you fully understand the contents of this manual.

BendPak HDS-14LSXE Specifications

General

Brand	BendPak
Model	HDS-14LSXE
Category	Lifting Systems
Language	English

Summary

Introduction and Safety Guidelines

Shipping Information

Guidelines for inspecting and handling shipment of the lift.

Safety Precautions

Crucial safety precautions and general safety information for lift use.

Lift Components

Identification and description of the main parts of the lift.

Installation Procedure

Planning and Site Preparation

Electrical planning, location selection, and site preparation for installation.

Assembly and System Connections

Steps for assembling components, connecting lines, and routing cables.

Power Unit and Final Setup

Installing power unit, electrical hookup, anchoring, and leveling.

Operation and Maintenance

Safe Lift Operation

Procedures for safely raising and lowering vehicles with the lift.

Routine Maintenance and Troubleshooting

Regular maintenance tasks and solutions for common lift issues.

Technical Resources

Wiring Diagrams

Electrical schematics for Power Unit 1 and Power Unit 2.

Parts Identification

Visual representation and listing of lift parts for replacement.