BendPak HD-9 - User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
HD-9 Four-Post Lift
Installation and Operation Manual
Manual P/N 5900123 — Manual Revision M — February 2020
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠
DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with installation and operation,
you agree that you fully understand the contents of this manual.
Models:
• HD-9ST
• HD-9STX
• HD-9
• HD-9XL
• HD-9XW
HD-9ST shown.

Summary

Safety Considerations

Safety Information

Electrical Information

Specifications

Installation Checklist

Installation

Being Safe

Emphasizes safety during installation, proper training, and using correct tools.

Using Tools

Planning for Electrical Work

Selecting a Location

Checking Clearances

Deciding the Lift Orientation

Moving the Posts into Position

Installing the Crosstubes

About Safety Locks

Installing the Ladders and Top Cap

Installing the Runways

Routing the Lifting Cables

Installing the Air Lines

Installing the Return Line

Hydraulic Fluid Contamination

Installing the Hydraulic Hose

Installing the Power Unit

Installing the Pushbutton Air Valve

Connecting the Return Line

Connecting the Hydraulic Hose

Contacting the Electrician

Connecting the Power Source

Installing a Power Disconnect Switch

Installing a Thermal Disconnect Switch

Anchoring the Posts

Final Leveling

Bleeding the Hydraulic Cylinder

Test the Lift

Final Checklist

Operation

Safety Considerations

Using the Controls

Raising and Lowering Vehicles

Maintenance

Wire Rope Inspection and Maintenance

Troubleshooting

Wiring Diagrams

BendPak HD-9 Specifications

General

Lifting Capacity	9, 000 lbs
Voltage	220V
Runway Width	19 inches
Power Requirements	220 VAC / 60 Hz / Single Phase
Warranty	5-year warranty on steel components / 1-year warranty on electrical, air and hydraulic power units