BendPak HD-9STX User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
HD-9 Four-Post Lift
Installation and Operation Manual
Manual P/N 5900123 — Manual Revision M — February 2020
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠
DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with installation and operation,
you agree that you fully understand the contents of this manual.
Models:
• HD-9ST
• HD-9STX
• HD-9
• HD-9XL
• HD-9XW
HD-9ST shown.

BendPak HD-9STX Specifications

General

Brand	BendPak
Model	HD-9STX
Category	Lifting Systems
Language	English

Summary

Introduction

Shipping Information

Safety Considerations

Safety Information

Lists essential safety precautions for operating HD-9 Four-Post Lifts.

Symbols

Liability Information

Electrical Information

Components

Optional Accessories

Specifications

Frequently Asked Questions

Installation Checklist

Installation

Being Safe

Emphasizes safety procedures and required PPE during lift installation.

Using Tools

Lists necessary tools required for the installation process.

Planning for Electrical Work

Selecting a Location

Checking Clearances

Deciding the Lift Orientation

Creating Chalk Line Guides

Unloading and Unpacking

Moving the Posts into Position

Guides on moving and positioning the lift posts according to chalk lines.

Installing the Crosstubes

About Safety Locks

Installing the Ladders and Top Cap

Raising the Crosstubes

Securing the Ladders

Removing the Sheaves

Installing the Runways

Installing the First End of the Flex Tube

Routing the Lifting Cables

Working with Compression Fittings and Tubing

Installing the Air Lines

Installing the Return Line

Hydraulic Fluid Contamination

About Thread Sealants

Installing the Hydraulic Hose

Installing the Power Unit

Filling the Hydraulic Fluid Reservoir

Installing the Second End of the Flex Tube

Installing the Pushbutton Air Valve

Connecting the Return Line

Connecting the Hydraulic Hose

Contacting the Electrician

Connecting the Power Source

Installing a Power Disconnect Switch

Installing a Thermal Disconnect Switch

About Effective Embedment

Anchoring the Posts

Final Leveling

Installing Accessories

Tire Stops Installation

Instructions for installing tire stops to secure vehicle wheels.

Drive-up Ramps Installation

Instructions for installing drive-up ramps for vehicle loading.

Caster Kit Installation

Instructions for installing the caster kit for moving the lift.

Lubricating the Lift

Bleeding the Hydraulic Cylinder

Test the Lift

Final Checklist

Outdoor usage

Operation

Safety Considerations

Lists critical safety checks to perform before each lift operation.

Using the Controls

Raising and Lowering Vehicles

Maintenance

Wire Rope Inspection and Maintenance

Details inspection and maintenance procedures for the lift's wire ropes (cables).

Troubleshooting

Wiring Diagrams

Labels

Parts Drawings

CE Declaration of Conformity

Automotive Lift Institute (ALI) Store