BendPak HD-7P User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Telephone: (805) 933-9970
bendpak.com
Four-Post Lifts
Installation and Operation Manual
Manual P/N 5900041 — Manual Revision M — July 2019
Models:
• HD-7P
• HD-7W
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠ DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with installation and operation,
you agree that you fully understand the contents of this manual.

BendPak HD-7P Specifications

General

Lifting Capacity	7, 000 lbs
Overall Width	135 inches
Overall Length	166 inches
Weight	1, 800 lbs
Drive-Thru Clearance	73 inches
Lifting Time	45 seconds
Power Requirements	110V / 220V
Power Unit	110-220 VAC / 50-60 Hz / 1 Ph

Summary

Introduction and Safety Information

General Safety and Owner Responsibility

Details safety rules, owner responsibilities, and unit information recording.

Electrical Information and Safety

Crucial electrical safety guidelines, wiring requirements, and warnings.

Installation Planning and Preparation

Installation Site and Safety Planning

Covers safe installation practices, required tools, and site preparation.

Location and Clearance Requirements

Core Installation Procedures

Crosstube, Ladder, and Safety Lock Installation

Lifting Cable Routing

Detailed instructions for routing the four lifting cables correctly.

Hydraulic, Air, and Return Line Installation

Power Unit and Electrical Connections

Installing and Filling the Power Unit

Steps for mounting the power unit and filling the hydraulic fluid reservoir.

Flex Tube and Pushbutton Valve Setup

Electrical Power Source Connection

Instructions for contacting electricians and connecting the lift to a power source.

Power Disconnect and Thermal Switches

Guidance on installing essential safety switches for power interruption.

Final Installation and Testing

Post Anchoring and Leveling

Procedures for anchoring posts, ensuring effective embedment, and final leveling.

Performing an Operational Test

Operation of the Lift

Operation Safety Considerations

Using the Controls

Raising and Lowering Vehicles Safely

Detailed steps for safely driving vehicles onto, raising, and lowering them.

Maintenance and Troubleshooting

Routine Lift Maintenance

Wire Rope Inspection and Lubrication

Troubleshooting Common Issues

Solutions for common problems encountered with the lift's operation.

Bleeding the Hydraulic Cylinder