HD-9 Series Four-Post Lifts 16 P/N 5900123 — Rev. M — February 2020
• Non-Slip Rubber Pads. If you do not plan to anchor the Lift (and want to use the optional
Caster Kit), you could go to your local hardware store and get non-slip Rubber Pads and size them
to fit the bottom of the Base Plates; the Pads will protect against scratches on special flooring if the
Lift accidentally shifts as a result of not anchoring the Lift. Use the Caster Kit to raise the Lift and
then put the Pads into place.
Checking Clearances
Out of the concern of safety, a certain amount of clear space around the Lift is
required
.
To Next Page
Loading...
