BendPak HD-14T User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
HD-14T Four-Post Lift
Installation and Operation Manual
Manual P/N 5900037 — Manual Revision F — February 2022
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠
DANGER
IMPORTANT SAFETY INSTRUCTIONS, SAVE THESE
INSTRUCTIONS! Save these instructions! Read the entire
contents of this manual before using this product. Failure to
follow the instructions and safety precautions in this manual can
result in serious injury or death. Make sure all other operators also
read this manual. Keep the manual near the product for future
reference. By proceeding with installation and operation, you
agree that you fully understand the contents of this manual
and assume full responsibility for product use
.
Models:
• HD-14T

BendPak HD-14T Specifications

General

Lifting Capacity	14, 000 lbs
Lifting Height	72 inches
Max Lift Height (with adapters)	72 inches
Motor	2 HP
Power Requirement	220V / 60Hz / 1Ph
Min Pad Height	4.5 inches
Drive-Thru Clearance	97 inches

Summary

Introduction

Shipping Information

Safety Considerations

Important Safety Information

Basic safety precautions for operating the lift, operator training, and equipment care.

Symbols

Liability Information

Components

Specifications

Frequently Asked Questions

Installation Checklist

Installation

Being Safe

Safety guidelines and requirements for personnel involved in the lift's installation.

Tools

List of necessary tools and equipment for the installation process.

Planning for Electrical Work

Electrical Information

Critical electrical requirements, safety notices, and circuit protection guidelines.

Selecting a Location

Checking Clearances

Deciding the Lift Orientation

Unloading and Unpacking

Creating Chalk Line Guides

Moving the Posts into Position

Installing the Crosstubes

About Safety Locks

Installing the Ladders and Top Cap

Raising the Crosstubes

Securing the Ladders

Removing the Sheaves

Installing the Runways

Routing the Lifting Cables

Working with Compression Fittings and Tubing

Hydraulic Fluid Contamination

About Thread Sealants

Installing the Hydraulic Hose

Installing the Return Line

Installing the Air Line

Installing the Power Unit

Filling the Hydraulic Fluid Reservoir

Installing the Flex Tube

Installing the Pushbutton Air Valve

Connecting the Return Line

Connecting the Hydraulic Hose

Connecting the Power Source

Installing a Power Disconnect Switch

Installing a Thermal Disconnect Switch

About Effective Embedment

Anchoring the Posts

Final Leveling

Installing Accessories

Tire Stops

Instructions for installing tire stops at the front of the runways to prevent over-travel.

Drive-up Ramps

Crosstube Covers

Bleeding the Hydraulic Cylinder

Perform an Operational Test

Final Checklist

Leave the Manual with the Owner/Operator

Operation

Safety Considerations

Crucial safety checks and precautions to perform before raising any vehicle.

Using the Controls

Raising and Lowering Vehicles

Maintenance

Wire Rope Inspection and Maintenance

Troubleshooting

Wiring Diagrams

Labels

Parts Drawings

Automotive Lift Institute (ALI) Store

Maintenance Log