HD-14T Four Post Lift 52 P/N 5900037 — Rev. F — February 2022
Installing a Power Disconnect Switch
WARNING A main Power Disconnect Switch is
not
provided with this equipment.
A Power Disconnect Switch is a National Electrical Code
(NEC) requirement. They are designed to interrupt
electrical power in the event of an electrical circuit fault,
emergency situation, or when equipment is undergoing
service or maintenance.
You must install a UL Listed Power Disconnect Switch
that is properly rated for the incoming power.
⚠ DANGER All wiring
must
be performed by a
licensed, certified Electrician in
accordance with national and local
codes.
Your Power Disconnect Switch must be readily
accessible and installed so that it is in easy reach of the
Lift operator. It must be clearly and legibly marked to
indicate its purpose.
The drawing to the right shows a toggle Power
Disconnect Switch between the Lift’s power source and
its Power Unit. A quick flip of the switch immediately
cuts power to the Lift.
Make sure to have a certified Electrician install the Power
Disconnect Switch.
Make sure the electrician selects a
UL-listed
Power
Disconnect Switch.
Installing a Thermal Disconnect Switch
⚠ WARNING The Lift’s motor does
not
have thermal overload protection.
Connect a motor Thermal Disconnect Switch or overload device that will make sure the equipment
shuts down in the event of an overload or an overheated motor.
⚠ DANGER All wiring
must
be performed by a licensed, certified Electrician in accordance with
national and local codes.
High electrical current that exceed the motor’s full load amps (FLA) rating may result in permanent
damage to the motor.
BendPak strongly recommends you
not
exceed the rated duty cycle of the Lift’s motor.
To Next Page
Loading...
