HD-14T Four Post Lift 51 P/N 5900037 — Rev. F — February 2022
To connect the Lift to a power source:
1. Have a certified, licensed Electrician locate the Pigtail coming out of the Electrical Box on the
Power Unit.
2. Open the Electrical Box, remove the Pigtail, and then either:
– Wire the Power Unit directly into the facility’s electrical system and protected by an appropriate
circuit breaker.
– Wire a Power Cord (with appropriate plug) inside the Electrical Box to the wiring that was
connected to the Pigtail.
Do not use the Pigtail
.
NOTICE The Power Cord and Plug are
not
supplied with the Lift.
See Wiring Diagrams for wiring information.
3. Close the Electrical Box.
4. When ready, connect the Plug into a 220 VAC power source.
To Next Page
Loading...
