HD-14T Four Post Lift 60 P/N 5900037 — Rev. F — February 2022
Final Checklist
Make sure these things have been done
before
putting the Lift into service:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Power Unit is getting power from the power source.
• Check the Hydraulic Fluid Reservoir on the Power Unit; it must be full of approved Hydraulic Fluid
or automatic transmission fluid.
You can damage the motor by running it without
enough fluid.
Check the Hydraulic System for leaks. Check for any loose Hydraulic Fittings and
Auxiliary Port Plugs. Inspect for pinched or damaged Hydraulic Hoses and replace them
before
operation.
• Make sure all four Posts are properly anchored, shimmed, level, and stable.
• Make sure all Cables are properly seated in their Cable Sheaves.
• Make sure all Safety Locks are operating normally. Verify that nothing is interfering with the Safety
Locks.
• Make sure the backup Slack Safety Locks are
not
engaged.
• If it has not already been done, lubricate all Cable Sheave Pins and the Cable Sheave Bore with
red lithium grease or similar.
• If it has not been done already, perform an Operational Test of the Lift with a typical Vehicle. Refer
to Test the Lift.
Leave the Manual with the Owner/Operator
Make sure to leave the Installation and Operation Manual with the owner/operator so that it is available
for anyone who needs to read it.
To Next Page
Loading...
