HD-14T Four Post Lift 21 P/N 5900037 — Rev. F — February 2022
Moving the Posts into Position
Use a Forklift or Shop Crane to move the Posts, one at a time, to the inside corners of the Chalk Line
Guides.
Important: Position the Power Post at your chosen location. Remember, the Power Post can only
go in two possible locations: the
Front Driver-Side
or the
Rear Passenger-Side
.
The other three Posts can go at any of the remaining Post locations. Refer to
Deciding the Lift Orientation for more information.
⚠ DANGER The Posts are extremely heavy; use caution when handling them. If they shift
position or fall, they could cause serious injury. Only allow trained personnel move
the Post and use appropriate lifting devices, such as a Forklift or Shop Crane.
Do not stand up the Posts yet
; some of the following procedures are easier to complete if the
Posts are laying on the ground.
To move the Posts into position:
1. Using a proper lifting device, move the Posts, one at a time, to the inside corners of the Chalk Line
Guides you created.
2. Do not anchor the Posts at this point.
To Next Page
