HD-14T Four Post Lift 57 P/N 5900037 — Rev. F — February 2022
Drive-up Ramps
The Lift uses Drive-up Ramps for Vehicles to be easily driven onto the Runways.
To install the Drive up Ramps:
1. Find the required components: two Ramps, two Ramp Pins, and four Rotor Clips.
2. Put a Ramp into position at the rear of the Runway, with the Ramp Tube aligned between the two
tubes attached to the Runway.
3. Slide a Ramp Pin through the top Runways tubes, then put two Rotor Clips on both ends of the
Ramp Pin.
Note: The Ramps are heavy and awkward, so you may want to consider having two people install
them; one to hold the Ramp, the other to put the components into place.
4. Repeat Steps 2 and 3 for the other Ramp.
Crosstube Covers
The Lift uses Crosstube Covers to protect the Gusset components.
To install the Crosstube Covers:
1. Find the four Crosstube Covers from the Parts Box.
2. Attach the Cover to the top of the Crosstube Gusset; do the same for the remaining Gussets.
To Next Page
Loading...
