BendPak HDS-14LSX User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
Four-Post Alignment Lifts
Installation and Operation Manual
Manual Revision F3 — April 2018 — Manual P/N 5900162
Models:
• HDS-14LSX
• HDS-14LSXE
Model HDS-14LSXE shown.
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠ DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with installation and operation,
you agree that you fully understand the contents of this manual.

BendPak HDS-14LSX Specifications

General

Brand	BendPak
Model	HDS-14LSX
Category	Lifting Systems
Language	English

Summary

Manual Overview

Owner Responsibility

User's duty to maintain safety and follow all installation, operation, and maintenance instructions.

Unit Information

Details required for warranty claims and parts identification.

Introduction

Shipping Information

Safety Considerations

Safety Information

Key safety points and recommendations for operating the lift.

Symbols

Additional Products

Components

Frequently Asked Questions

Specifications

Installation Checklist

Installation

Being Safe

Emphasizes safety protocols and protective equipment during installation.

Using Tools

Lists the necessary tools required for the lift installation process.

Planning for Electrical Work

Selecting a Location

Unloading and Unpacking

Creating Chalk Line Guides

Moving the Posts into Position

Installing the Crosstubes

About Safety Locks

Installing the Ladders and Top Cap

Raising the Crosstubes

Securing the Ladders

Installing the Runways

Installing the Flex Tube

Working with Compression Fittings and Tubing

Installing the Return Line

Installing the Air Lines

Installing the Hydraulic Line

Routing the Cables

Installing the Power Unit

Installing the Flex Tube

Installing the Pushbutton Air Valve

Connecting the Return Line

Connecting the Hydraulic Line

Contacting the Electrician

Connecting the Power Source

Installing a Power Disconnect Switch

Installing a Thermal Disconnect Switch

Anchoring the Posts

Final Leveling

Installing Accessories

Tire Stops

Installing safety features to prevent vehicle front tires from overshooting runways.

Ramps

Attaching ramps for safe vehicle access to the lift runways.

Alignment Turn Plates

Lubricating the Lift

Bleeding the Hydraulic Cylinder

Performing an Operational Test

Final Checklist Before Operation

Operation

Safety Considerations

Essential precautions to take before and during lift operation.

Using the Controls

Instructions for operating the lift's up and down control buttons.

Raising and Lowering Vehicles

Maintenance

Wire Rope Inspection and Maintenance

Troubleshooting

Wiring Diagrams

Labels

Parts Drawings

CE Declaration of Conformity

Maintenance Log