HDS-14LSX / HDS-14LSXE Lifts 32 P/N 5900162 — April 2018 — Rev. F3
Installing the Hydraulic Line
The Hydraulic Line moves hydraulic fluid from the Power Unit to the Hydraulic Cylinder, which raises
the Runways.
To install the Hydraulic Line, you will need:
• The Hydraulic Line. The Curved end attaches at the Hydraulic Cylinder and the Straight end
comes out the Flex Tube so that it can attach at the Power Unit.
• One JIC to NPT hydraulic fitting. The JIC end attaches to the Curved end of the Hydraulic
Line and the NPT end to the Hydraulic Cylinder.
• One JIC to ORB hydraulic fitting. The JIC end attaches to the Straight end of the Hydraulic
Line and the ORB end to the Power Unit.
The following drawing shows where the Hydraulic Line goes on the Lift.
Drawing not to scale. Not all components shown.
To Next Page
Loading...
