HDS-14LSX / HDS-14LSXE Lifts 3 P/N 5900162 — April 2018 — Rev. F3
Table of Contents
Introduction 3 Installation 12
Shipping Information 4 Operation 61
Safety Considerations 4 Maintenance 64
Additional Products 5 Troubleshooting 66
Components 6 Wiring Diagrams 67
FAQs 8 Labels 68
Specifications 9
Parts Drawings 71
Installation Checklist 11 Maintenance Log 79
Introduction
This manual describes the following BendPak four-post Alignment Lifts:
• HDS-14LSX: Four-post Alignment Lift that can raise vehicles up to 14,000 pounds (6,350 kg).
ALI- and CE-certified.
• HDS-14LSXE: Four-post Alignment Lift with extended Runways that can raise vehicles up to
14,000 pounds (6,350 kg). ALI- and CE-certified.
This manual is mandatory reading for all users of the HDS-14LSX and HDS-14LSXE, including anyone
who installs, uses, maintains, repairs, or wants to know more about them.
⚠ DANGER Use care when installing, operating, maintaining, or repairing this equipment; failure
to do so could result in property damage, product damage, injury, or (in very rare
cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions in this manual and on the
labels on the unit.
Keep this manual on or near the equipment so that anyone who uses or services it can read it.
If you are having issues, refer to the Troubleshooting section of this manual for assistance.
Technical support and service is available from your dealer, on the Web at bendpak.com/support,
by email at techsupport@bendpak.com, or by phone at (800) 253-2363, extension 196. You
may also contact BendPak for parts replacement information at (800) 253-2363, extension 191;
please have the model and serial number of your unit available.
To Next Page
Loading...
