HDS-14LSX / HDS-14LSXE Lifts 12 P/N 5900162 — April 2018 — Rev. F3
Installation
The installation process takes multiple steps. Perform them in the order listed.
Read the entire
Installation section before beginning the install
; this gives you a better understanding of the
process as a whole.
⚠ WARNING
Only use the factory-supplied parts that came with your Lift
. If you use
parts from a different source, you void your warranty and compromise the safety of
everyone who installs or uses the Lift. If you are missing parts, visit
bendpak.com/support or call (800) 253-2363, extension 191.
Being Safe
While installing this equipment, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive Lift installation training.
Always use proper lifting tools, such as a Forklift or Shop Crane, to move heavy
components. Do not install this equipment without reading and understanding this
manual and the safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Pay attention at all times.
Use appropriate tools and lifting equipment. Stay clear of moving parts.
BendPak recommends referring to the ANSI/ALI ALIS Standard (R2015) Safety Requirements for
Installation and Service for more information about safely installing, using, and servicing your Lift.
⚠ WARNING You must wear appropriate protective equipment
at all times
: gloves, steel-toed
work boots, eye protection, back belts, and hearing protection.
Using Tools
You may need some or all of the following tools:
• Rotary hammer drill (or similar)
• ¾ inch carbide bit (conforming to ANSI B212.15-1994)
• Hammer and crow bar
• Four-foot level
• Open-end wrench set, SAE and metric
• Socket and ratchet set, SAE and metric
• Hex key wrench set
• Medium crescent wrench, torque wrench, pipe wrench
• Chalk line
• Medium-sized flat screwdriver and needle-nose pliers
• Tape measure (25 feet or above)
• Forklift, shop crane, or heavy-duty rolling dolly, and two sawhorses
• 12-foot ladder
To Next Page
Loading...
