BendPak HDS-14LSX - Symbols; Additional Products

HDS-14LSX / HDS-14LSXE Lifts 5 P/N 5900162 — April 2018 — Rev. F3
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in death or severe injury.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in death or severe
personal injury.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product damage, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.
Liability Information
BendPak Inc. assumes no liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
Additional Products
There are additional products you can use with your Lift:
• Aligner. An Aligner is a hardware/software product that lets you perform wheel alignments. If you
already have an Alignment Lift, like an HDS-14LSX or HDS-14LSXE, simply purchase the Aligner
and you can start performing wheel alignments.
Refer to the Aligner page on the BendPak website for more information.
• Rolling Bridge Jack. A Rolling Bridge Jack raises the wheels of a vehicle off the Runways of a
Lift, like an HDS-14LSX or HDS-14LSXE, making it much easier to perform service such as brake
jobs and suspension work while the vehicle is still on the Lift.
You can raise two wheels off the Runways if you have one Rolling Bridge Jack. It takes two Rolling
Bridge Jacks to raise all four wheels off the Runways.
Refer to the Rolling Bridge Jack page on the BendPak website for more information.
• WSA-100 Air/Electric Workstation. The Air/Electric Workstation adds air and electric
capabilities to your Lift. It includes four electrical outlets and specialized air service outlets, among
other features. Refer to the WSA-100 Air/Electric Workstation page on the BendPak
website for more information.
Note that SKU 5210439 is optimized for the HDS-14LSX and HDS-14LSXE Alignment Lifts.