LR-10000 Low-Rise Scissor Lift 26 P/N 5900075 — Rev. B — August 2021
Install a Thermal Disconnect Switch
⚠ WARNING The motor on the LR-10000 Power Unit has no thermal overload protection.
Have an Electrician connect a motor Thermal Disconnect Switch or overload device that will make sure
the equipment shuts down in the event of an overload or an overheated motor.
⚠ DANGER Installing a Thermal Disconnect Switch
must
be performed by a licensed, certified
Electrician in accordance with national and local electrical codes. Do not perform
any
maintenance or installation on the Lift without first making sure that main
electrical power has been disconnected from the lift and
cannot
be re-energized
until all procedures are complete.
High electrical current that exceeds the motor’s full load amps (FLA) rating may result in permanent
damage to the motor.
Do not exceed the rated duty cycle of the motor.
Final Checklist Before Operation
Make sure the following items have been done before using your Lift:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Power Unit is getting power from the power source.
• Check the Hydraulic Fluid reservoir; it must be full of approved Hydraulic Fluid or automatic
transmission fluid.
You can harm the motor by running it without enough fluid.
• Check the Hydraulic System for leaks. Verify all Hydraulic Hose connections, Hydraulic Fittings,
and Auxiliary Port Plugs on the Lift and Power Unit are tight.
• Check to see that all Anchor Bolts are appropriately shimmed and correctly torqued.
• Make sure that all Safety Locks are cleared and free.
Leave the Manual with the Owner/Operator
Make sure to leave the Installation and Operation Manual with the owner/operator so that it is available
for anyone who needs to read it.
To Next Page
Loading...
