LR-10000 Low-Rise Scissor Lift 28 P/N 5900075 — Rev. B — August 2021
If the Vehicle is
not
stable and balanced, lower the Lift back to the ground and start over.
If the Vehicle
is
stable and balanced, it is safe to raise further.
⚠ DANGER Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is
not
stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, or injure or kill anyone under the Vehicle.
13. On the Power Unit, press and hold the Raise button.
14. Watch the Vehicle and the Platforms as they rise.
If the Lift becomes unstable or the Vehicle starts moving, release the Raise button immediately.
15. When the Platforms are
the desired height, release the Raise button.
16. Press the Lowering Handle on the Power Unit to move the Platforms back down a bit, which
engages them on the most recently passed Safety Lock.
If you miss the Safety Lock, press and hold Raise again and go somewhat further past the Safety
Lock, then hold the Lowering Handle again to engage the Lift on the Safety Lock.
17. To lower the Lift back down to the ground, pull up on the Safety Lock Release Handle, then press
and hold the Lowering Handle until the Lift is fully lowered.
If the Lift was shaking, moving erratically, or squeaking, raise and lower the Lift again to help bleed
the Hydraulic System.
If you continue to have issues, refer to Troubleshooting for assistance.
To Next Page
Loading...
