SP-7XE/F Full-Rise Scissor Lift 53 P/N 5900010 — Rev. B3 — September 2023
• Never leave the Controls while the Lift is still in motion.
• Do not rock the Vehicle while on the Lift or remove any heavy component from Vehicle that may
cause excessive weight shift.
• Do not permit the Power Unit to become wet. The motor can be damaged and water damage is
not covered under the product warranty.
• Always allow a minimum of 2 seconds delay between motor starts. Failure to comply may cause
Switch and/or Motor burnout. This could cause serious damage to the equipment.
• If any part of the Vehicle’s Lifting Points are not completely over the Platform, carefully drive the
Vehicle back off the Lift and then drive it back on to reposition it, making sure to keep the Wheels
in the middle of the Platforms.
⚠ WARNING You must use the Vehicle manufacturer’s recommended Lifting Points. If you fail to
do so, the Vehicle may become unstable and fall off the Pads and/or the Lift which
could damage the Vehicle, the Lift, or injure or kill anyone under the Vehicle.
⚠ WARNING Before raising a Vehicle, verify there is at least 1 inch / 25 mm of clearance between
the Lift Pads and the Vehicle. The Lift cannot raise a full load from a completely flat
starting position, and attempting to lift in this manner will damage the Lift and could
injure persons nearby.
⚠ WARNING Do not lower a Vehicle all the way to the floor with the wheels removed. Failure
to comply with these instructions will void the product warranty.
BendPak will assume no liability for loss or damage of any kind, expressed or
implied resulting from improper installation or use of this product.
To Next Page
Loading...
