SP-7XE/F Full-Rise Scissor Lift 54 P/N 5900010 — Rev. B3 — September 2023
⚠ WARNING Never raise a Vehicle with the center of Gravity shifted off the Platforms.
Raising a Vehicle
This section describes how to position a Vehicle on the Lift and raise it.
⚠ WARNING Always use care when you are around the Lift. When it is in a lowered position, be
careful not to trip over it. When it is raised, be careful not to bang into a Drive-up
Ramp or a Platform. When the Lift is moving, keep all people, animals,
and objects at least 30 feet away from it.
To raise a Vehicle:
1. Check the items listed in Lift Operation Safety.
If you find any issues, resolve them before raising the Vehicle.
2. Make sure both Platforms are on the ground.
3. Drive the Vehicle over the Platforms and center it on the Platforms.
4. Put the Vehicle in park, put on the parking brake, and turn off the Vehicle.
If the Vehicle is a manual transmission, put it into first gear before turning it off.
5. Walk around the Vehicle and make sure there are no obstructions or any other issues that will
interfere with the raising of the Platforms.
6. At the Console, press and hold the Raise button.
7. Watch the Vehicle and the Platforms as they rise.
If the Lift becomes unstable or the Vehicle starts moving, release the Raise button immediately.
⚠ WARNING Do not raise the Lift any farther until you are certain the Vehicle on the Lift is both
stable and balanced. If the Vehicle is not stable and balanced, it could fall, which
could damage the Vehicle, damage the Lift, or injure or kill anyone under the Lift.
8. When the Platforms are just past the desired height, release the Raise button.
9. Press the Lower button briefly to move the Platforms back down, which engages them on the
most recently passed Safety Lock.
To Next Page
Loading...
