SP-7XE/F Full-Rise Scissor Lift 55 P/N 5900010 — Rev. B3 — September 2023
If you do not go far enough past the desired Safety Lock and then lower the Platforms, you may
miss engaging on the Safety Lock. This means that if you continue to hold the Lower button, the
Platforms will go all the way back to the ground.
If you miss the desired Safety Lock, press and hold Raise again and go somewhat farther past
the desired Safety Lock. Release Raise, then hold Lower again to lower the Platforms onto the
desired Safety Lock.
Lowering a Vehicle
This section describes how to lower a Vehicle from a raised position.
To lower a vehicle:
1. Check the items listed in Lift Operation Safety.
If you find any issues, resolve them before lowering the vehicle.
2. At the Console, press and hold the Raise button for a second or two.
This moves the Platforms off the engaged Safety Lock.
3. Press and hold Safety Lock Release, then press and hold Lower.
If you do not press and hold the Safety Lock Release, the Lift will engage on the next Safety Lock.
⚠ WARNING Always verify both Safety Locks disengage when the Safety Lock Release button is
pressed. If one of the Safety Locks inadvertently engages on descent, the Lift and
Vehicle may become unbalanced and can cause severe injury or death.
4. Carefully drive the Vehicle off the Platforms.
To Next Page
Loading...
