7
BLOWER FUNCTION:
Your Bennett Read Tough 35 has an additional function that allows you to blow away dirt and
dust that collect on various surfaces and hard to reach areas.
Setting up your Bennett Read Tough 35 to use the blower function:
1. Remove the Motor Unit (3) from the Dirt Tank (4) by pushing the Locking Clips (16) outwards
2. Ensure that the Microparticle filter is securely installed in place
3. Replace the Motor Unit (3) and lock clips in place (16)
WET VACUUMING:
Your Bennett Read Tough 35 can also suck up liquids
*
in and around your home…
Setting up your Bennett Read Tough 35 for wet vacuuming:
1. Remove the Motor Unit (3) from the Water/dirt Tank (4) by pushing the Locking Clips (16)
outwards
2. Remove the Microparticle filter (20) (as explained in the Maintenance and Care section on
the following page)
3. Return the Motor Unit (3) to the Dirt Tank (4) and clip locks in place (16) by pushing
inward
4. Insert the large end of the Flex Hose (10) into Vacuum Function Hose Port (2)
5. Attach the Extension Tubes (12) to the free end of the Flex Hose
6. Attach the Wet Pick-up Vacuum Nozzle (14) to the free end of the Extension Wand
7. Plug the Power Cable into the wall socket
8. Switch on unit using the Power Switch (1)
9. Vacuum wet spill / liquid from surface
10. When you are done, follow the cleaning instructions as outlined below
After each cleaning session it is of utmost importance that:
• The dirt tank be emptied and thoroughly rinsed and dried before storing
• The Microparticle filter is checked and cleaned
This will ensure that the unit continues to deliver outstanding performance time & again
*Please note that the Bennett Read Tough 35 is NOT a carpet deep cleaner.
Carpet deep cleaning should be done with specialized deep cleaners.
*Do not use to pick up boiling hot, flammable or combustible liquids
Your Bennett Read Tough 35 is equipped with a float valve located at the
bottom of the motor unit which will partially shut off the suction as soon
as the tank reaches capacity. Immediately switch off the machine and empty
the tank before continuing.
3. Return the Motor Unit (3) to the Dirt Tank (4) and clip locks in place (16) by pushing
inward
4. Insert the large end of the Flex Hose (10) into Vacuum Function Hose Port (2)
5. Attach the Extension Tubes (12) to the free end of the Flex Hose
6. Attach the Multi-Surface Vacuum Nozzle (13) to the free end of the Extension Wand
7. Plug the power cable into the wall socket
8. Switch on the unit using the Power Switch (1)
9. Vacuum in different directions across your surfaces to give you best results
To Next Page
Loading...
