EasyManua.ls Logo

Bennett 3711 User Manual

Default Icon
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
120001 Rev K 1-19-18
Bennett 1218 E. Pontaluna Road, Spring Lake, MI 49456
USA 800-235-7618 Outside USA 231-798-1310 sales@bennettpump.com
www.bennettpump.com
Includes Instructions For:
All 3700 Electronic Commercial Dispensers
All 3800 Electronic Retail Dispensers
Remote Dispensers
and
Self-Contained Pumps
For new manuals, FAX to:
BENNETT MARKETING
SERVICES
(231)799-6202
or visit our web page at:
http://www.bennettpump.com
Bennett Pump Company
Commercial and Retail Dispensers
3700/3800 Series Spec. 100 (2nd Generation)
Electronic Commercial & Retail Installation Manual
Only Trained Personnel May Work on This Equipment
READ THIS MANUAL
This manual has important information for safe installation and
operation of this equipment. Read and understand this manual
before applying power. Keep this manual and tell all service
personnel to read this. If instructions are not followed then
bodily injury, death or damage to the equipment may occur.

Table of Contents

Other manuals for Bennett 3711

Question and Answer IconNeed help?

Do you have a question about the Bennett 3711 and is the answer not in the manual?

Bennett 3711 Specifications

General IconGeneral
BrandBennett
Model3711
CategoryDispenser
LanguageEnglish

Summary

Safety Instructions

Determining the Model Number

Product Specifications

Power Requirements

Details electrical power input and output specifications.

Dispenser Identification Number Summary (DIN)

Unloading, Unpacking, and Inspecting a New Dispenser

Electrical Field Wiring General Information

Wiring the 3700 Series Dispenser Commercial

Determine the Number of Wires Needed

Console Communications

Lists wires for RS485 communication with control consoles.

Mechanical Pulse Output Wiring

Proper Equipment Grounding

AC Power Installation

Connecting Sub Pump Control Wiring for Remote Dispensers

Installing RC Networks

Connecting Pump Motor Power for Suction Pump Systems

Connecting the Communication Wires

Connecting the Field Wires to the Mechanical Interface Board

Setting the Jumpers on the Pulse Output Board

CPU Board Jumper Configuration

Dispenser Startup and Checklist

Self-Contained Startup Procedures

How to Mechanically Calibrate the SB-100 Meter (M-Cal Option)

How to Electronically Calibrate the SB-100 Meter (E-Cal Option)

Wiring the 3800 Series Dispenser Retail

Determining the Number of Wires Needed

Dispenser Power

Lists wires needed for basic dispenser power.

Connecting Suction Pump Motor Power

How to Electronically Calibrate the SB-100 Meter

Basic Calibration Procedure

Step-by-step guide for basic electronic meter calibration.

Direct Percent Entry Procedure

Related product manuals