Bennett 3811 User Manual

© 2002 BENNETT PRINTED IN U.S.A. Manual #108796 Rev. C, 07/05
Includes Instructions
For:
Standard 3000 Electronic
Retail Dispensers (Go
Pump—R 3k)
3000 Little Squirt - Retail
Dispensers
3000 Big Squirt - Retail
Dispensers
READ THIS BOOK
This book has important information for safe
installation and operation of this equipment.
Read and understand this book before applying
power. Keep this book and tell all service
personnel to read this book. If you do not follow
the instructions, you can cause bodily injury,
death or damage to the equipment.
For new books, FAX to:
BENNETT MARKETING SERVICES
(231)799-6202
or visit our web page at:
http://www.bennettusa.com
Operators Manual
3000 Series Retail Dispensers
with 210 Electronics

Bennett 3811 Specifications

General

Brand	Bennett
Model	3811
Category	Dispenser
Language	English

Summary

READ THIS BOOK

SAFETY INSTRUCTIONS

PRODUCT SPECIFICATIONS

PUMP CONTROL DEVICES

Manager's Keypad

Description of the manager's keypad for programming and accessing dispenser functions.

Error Messages

Information on how to interpret and respond to error messages displayed by the dispenser.

OPERATING THE DISPENSER

How to Dispense Fuel

Step-by-step instructions for dispensing fuel using the dispenser's standard operation.

Dispensing Fuel with Local Preset

Procedure for dispensing fuel when the Local Preset option is utilized.

READING TOTALS

Electro-mechanical Totalizer

Explanation of the cumulative, non-resettable volume records on the electro-mechanical totalizer.

Displaying Electronic Totals

Methods for accessing and viewing the electronic totals displayed by the dispenser.

Reading Electronic Totals

Details on interpreting the money and volume totals displayed electronically.

PREPARING FOR PROGRAMMING

Connecting Manager's Keypad

Instructions for connecting the manager's keypad to the dispenser for programming.

PREPARING DISPENSER FOR OPERATION

Access Manager's Mode (Menu Code 3)

Steps to enter the Manager's Mode using the access code for programming.

Change Manager's Access Code

Procedure for changing the four-digit manager access code.

CHANGING SECURITY CODE ACCESS (MENU CODE 3)

PROGRAMMING PRICE PER VOLUME (MENU CODE 4)

CHANGING DECIMAL POINT LOCATIONS (MENU CODE 8)

SETTING NO FLOW TIME OUT (MENU CODE 9)

SETTING SLOW FLOW AMOUNT (MENU CODE 10)

SETTING VOLUME ALLOCATION LIMIT (MENU CODE 11)

PROGRAMMING SUBMERGED PUMP PRE-CHARGE TIME (MENU CODE 12)

PROGRAMMING FLEET OPTION (MENU CODE 15)

PROGRAMMING LOCAL PRESET OPTION (MENU CODE 17)

PROGRAMMING MOTOR DELAY (MENU CODE 18)

SETTING DISPENSER MODE OF OPERATION (MENU CODE 21)

SETTING DISPENSER ADDRESS (MENU CODE 22)

LOCAL PRESET DATA ENTRY DIGIT POINTER (MENU CODE 24)

VIEWING ELECTRONIC CALIBRATION (MENU CODE 27)

PERFORMING COLD START (MENU CODE 83)

Lost or Forgotten Password Recovery

Procedure to recover or reset the manager's access code, potentially involving breaking calibration seals.

CONFIGURING UNIT OF MEASURE (MENU CODE 99)

PROGRAMMING DISPENSER USING LOCAL PRESET

MECHANICALLY CALIBRATING SB-100 METER (M-CAL OPTION)

ELECTRONICALLY CALIBRATING METERS (E-CAL)

Setting Electronic Calibration

Step-by-step guide for performing electronic calibration on SB-100 and FPP meters.