BenQ C600 - Basic Operations and Call Handling




BenQ C600 Mobile Phone
Basic Operations
When the phone power is off, you can long press key to turn it
on. The phone beeps with a piece of music and a welcome animation
will appear on the screen. After the phone is turned on, it will start
searching for the network to use.
When network service is acquired, the banner will be displayed on
the screen. Under this "standby" mode, you can:
• Make a call.
• Press the “Menu” soft key to access
Main Menu
.(See “Chapter
3: Menu Options” on page 23)
• Press the “Book” soft key to enter the
Phone Book
. (See
“Phone Book Menu” on page 25 )
• Long press the key to listen to the voice mail message.
• If you have activated the Lock Phone/Power On function, the phone will be
locked and you will need to enter the lock code to unlock it.
When the phone power is on, you can long press key to turn it
off.
In standby mode, you can make a call in one of the following ways:
• Key in the phone number, then press key.
• Press key to browse the last dialed numbers list, then press
key again to dial.
• Long press key to redial the last dialed number.
• Find a Phone Book record by name and press key.
• Long press ~ key to use speed dial.
• From "Outgoing Call" log, choose a number to dial and press
key.
Turning on the phone
Turning off the phone
Making a call