BenQ DC 5530 User’s Manual
English
Preparing Your DC E300 for Use 5
2 PREPARING YOUR DC E300 FOR USE
You can use either 2 AAA size batteries (Alkaline or Ni-MH) to power the camera.
2.1 Installing Batteries
1. Make sure the camera is turned off.
2. Slide the battery cover in the direction of the
[OPEN] arrow.
3. Insert the batteries, noting correct polarity (+ and
-).
4. Close the battery cover firmly.
Note
•
Different battery types and surrounding temperatures may affect the battery
performance.
• Avoid using batteries in extremely cold environments as low temperatures can shorten
the battery life and reduce camera performance. This low temperature will also
influence Alkaline battery performance, therefore Ni-MH rechargeable battery is highly
recommended.
• If you are using the new rechargeable batteries or rechargeable batteries that have not
been used for an extended period of time (batteries that pass the expiry date are
exceptions) might affect the number of pictures that can be taken. Therefore, to
maximize their performance and lifetime, we recommend that you fully charge the
batteries and discharge them for at least one complete cycle before use.
• If you will not be using the batteries for an extended period of time, remove them from
the camera to prevent leakage or corrosion.
• Never use batteries of different types (together) or mix old and new batteries.
• Never use manganese batteries.
To Next Page
Loading...
Need help?
General
