BenQ EH620 - Page 49

49 Operation (under non-Launcher source)
Network
Settings
Image
Resizing
Digital Zoom
Magnifies or reduces the projected image size.
1. After the adjustment bar displays, press / repeatedly to reduce or magnify
the image to a desired size.
2. Press OK to enter panning mode.
3. Press the directional arrows ( , , , ) on the projector or remote control
to navigate the picture.
The picture can only be navigated after it is magnified. You can further magnify the picture while
searching for details.
Digital Shrink & Shift
Shrinks and/or shifts the projected image.
1. After the adjustment bar displays, press / repeatedly to shrink or magnify
the picture to a desired size.
2. Press OK to activate digital shift function.
3. After digital shift function is activated, press the directional arrows ( , , ,
) to shift the image.
4. Press AUTO to restore the picture to its original size.
The picture can only be shifted after it shrank.
Reset Display
Returns all of the adjustments you’ve made for the Display menu to the factory
preset values.
Wired LAN See Controlling the projector via LAN on page 53.
AMX Device
Discovery
When AMX Device Discovery is On, the projector can be detected by AMX
controller.
MAC Address
(Wired)
Displays the Mac Address for this projector.
Projector
Installation
See Choosing a location on page 13.
Remote
Receiver
Allows you to enable all the remote receivers or one specific remote receiver on
the projector.
Auto Source
Search
Allows the projector to automatically search for a signal.
Auto Sync
• On: Allows the projector to automatically determines the best picture timings for
the displayed image when PC signal (analog RGB) is selected and AUTO is
pressed.
• Off: The projector will not respond when AUTO is pressed.