60 Maintenance
14. Replace the lamp cover on the projector.
15. Tighten the screw that secures the lamp cover.
16. .Connect the power and restart the projector.Resetting
the light timer
17. After the startup logo, open the On-Screen Display
(OSD) menu. Go to Advanced Menu- Settings > Light Settings and press OK. The Light
Settings page appears. Highlight Reset Light Timer and press OK. A warning message is
displayed asking if you want to reset the light timer. Highlight Reset and press OK. The light time
will be reset to “0”.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
Do not reset if the lamp is not new or replaced as this could cause damage.
To Next Page
Loading...
