BenQ HT9050 - SYSTEM SETUP: ADVANCED Menu

29 Menu operation
SYSTEM SETUP: ADVANCED menu
Menu Settings
• Menu Position: Sets the On-Screen Display (OSD) menu position.
• Menu Display Time: Sets the length of time the OSD will remain active after
your last key press.
• Reminder Message: Sets the reminder messages on or off.
Source
Rename
Renames the current input source to your desired name.
On the Source Rename page, use / / / to set the desired characters for the
connected source item.
When done, press OK to save the changes.
Auto Source Allows the projector to automatically search for a signal.
Lamp Settings
• Reset Lamp Timer
Use this function only when a new lamp is installed. To reset the lamp timer,
highlight Reset Lamp Timer and press OK. A warning message is displayed.
Highlight Reset and press OK. The lamp time will be reset to “0”.
Do not reset if the lamp is not new or replaced as this could cause damage.
• Lamp Timer: See Getting to know the lamp hour on page 32.
HDMI
Settings
• HDMI Range
Selects a suitable RGB color range to correct the color accuracy.
• Auto: Automatically selects a suitable color range for the incoming HDMI
signal.
• Full Range: Utilizes the Full range RGB 0-255.
• Limited Range: Utilizes the Limited range RGB 16-235.
• CEC
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, turning on the HDMI CEC compatible device automatically turns on
the projector, while turning off the projector automatically turns off the HDMI CEC
compatible device.
• Power On Link/Power Off Link
When you connect an HDMI CEC-compatible device to your projector with an
HDMI cable, you can set the behavior of powering on/off between the device and
the projector.
Password See Utilizing the password function on page 20.
Bidirectional
Turning on/off either the connected device or the
projector can turn on/off both.
From Projector
When the projector is turned on/off, the connected
device will be activated/shut down, too.
From Device
When the connected device is turned on/off, the
projector will be activated/shut down, too.