BenQ LU935 - Page 44

44 Menu operation
System
Serial Port
Setting
• Port Selection: Allows you to select a preferred control port: through the
RS-232C port (RS232 port on the projector) or the HDBaseT port (HDBaseT
input port on the projector).
• Baud Rate: Selects a baud rate that is identical with your computer’s so that you
can connect the projector using a suitable RS-232 cable. This function is intended
for qualified service personnel.
HDMI
Equalizer
Adjusts the equalizer gain settings for an HDMI signal. The higher the setting, the
stronger the gain value. If there are more than one HDMI port on the projector,
select the HDMI port first before adjusting the value.
Image
Memory
• Save Image Memory: Allows you to save and apply several sets of image
settings for regularly used circumstances, including the following settings:
Projector Installation, Aspect Ratio, Picture Mode, Source, Resolution,
Light Source Mode, Digital Shrink & Shift, Blanking. You can choose one
set of memory to save the current settings.
• Apply Image Memory: After the image memories are saved, you can decide if
you would like to apply it by choosing a set of memory that you have saved.
• Rename: Renames the image memories.
Reset Settings
Returns all of the adjustments you’ve made for the Settings menu to the factory
preset values.
Language Sets the language for the On-Screen Display (OSD) menus.
Standby
Settings
• Standby Mode
• ECO: The projector maintains at normal standby mode with less than 0.5W
power consumption.
• Network: The projector maintains at network standby mode with less than
2W power consumption.
• Normal: Allows the projector to provide network, monitor out and audio
pass through functions in standby mode.
• Auto Disable Network Standby Mode: Allows the projector to disable the
network function after a set period of time after it enters standby mode. For
instance, if 20 min is selected, the projector is able to provide the network
function for 20 minutes after it enters standby mode. When 20 minutes is up, the
projector enters normal standby mode.
• Audio Pass Through: The projector can play sound when it is in standby mode
and the corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. See Connection on page 19 for how to
make the connection.
Background
Settings
• Background: Sets the background color for the projector.
• Splash Screen: Allows you to select which logo screen will be displayed during
projector start-up.
Menu Settings
• Menu Type: Switches to the Basic OSD menu.
• Menu Display Time: Sets the length of time the OSD will remain active after
your last key press.