BenQ MH760 - Page 57

57
Using the projector
English
Information menu
This menu shows you the current operating status of the projector.
Some picture adjustments are available only when certain input sources are in use. Unavailable adjustments
are not shown on the screen.
Standby Settings
Network
Selecting On enables the function. The projector is able to provide the
network function when it is in standby mode.
Monitor Out
Selecting On enables the function. The projector can output a VGA signal
when it is in standby mode and the PC jack is correctly connected to devices.
See "Connecting a monitor" on page 20 for how to make the connection.
Audio Pass Through
Press / to choose the source that you wish to use in operation mode. See
"Connecting to video equipment" on page 17 for how to make the connection.
When corresponding jacks are correctly connected to the device, the
projector can output an audio signal to the external speaker when it is in
standby mode. The built-in speaker(s) will be muted in standby mode.
Enabling this function slightly increases the standby power
consumption.
Network Settings
Wired LAN
See "Controlling the projector through a Wired LAN environment" on page 42
for details.
Reset All Settings
Returns all settings to the factory preset values.
The following settings will still remain: names of user modes, 2D
Keystone, Color Space Conversion, Language, Projector
Installation, High Altitude, and Password.
Function Description
Native Resolution
Shows the native resolution of the input signal.
Detected Resolution
Shows the detected resolution of the input signal.
Source
Shows the current signal source.
Picture Mode
Shows the selected mode in the Picture > Picture Mode menu.
Lamp Mode
Shows the selected lamp mode in the System Setup: Advanced > Lamp
Mode
menu.
3D Format
Shows the current 3D mode. Only available when 3D mode is enabled.
Color System
Shows input system format.
Lamp Usage Time
Shows the total lamp time used.
Firmware Version
Shows the current firmware version.